Karltron Saws Oscillator

Cost: $100
Difficulty: Moderate

Available in black or white panel, this is a triple ramp oscillator with analog detune for fat leads. This build is fully Through-hole construction which some folks may prefer but it will take the full workshop time to complete and is not recommended for a first project.

Karltron Tube Waveshaping VCA

Cost: $100
Diffuculty: Easy

Available with a black or white panel. A tube-based voltage controlled amplifier with overdrive and analog harmonics. It's pre-populated SMD and just jacks/pots to be done by the builder.

CMP Utility Module

Cost: $60
Difficulty: Easy

Available only in black, white panel shown. This dual comparator can make gates or square tones from your signals. This project is through-hole but has very few parts and is considered a good first-time project..

TO PARTICIPATE IN THIS WORKSHOP
You will need to purchase one of the kits available from Karltron by sending the appropriate funds via paypal by clicking THIS LINK and put the Module Name in the description.

Some kits may be available for purchase on-site, however, you can secure your place in the workshop by pre-ordering your kit.